Heresa some tips I picked up off a few sites feel free to add!!
1) Microphone Techniques: In order to achieve a professional high fidelity vocal recording, using a condenser mic along with a good pop-screen is the only way to go. Condensers capture vocal resonance and vocal frequency spectrums far better than dynamic microphones. Also, before recording, be certain to switch the mic's settings to the cardioid pickup pattern with the high pass filter enabled to remove low end rumble from the source recording signal.
2) Vocal EQ Techniques: If proper microphone techniques have been implemented, a minimal amount of EQ should be needed. However, if you find the vocals could still use added clarity, try boosting 1-3 decibels between 5khz - 7khz. If you're needing an extra airy texture added to the vocals, try boosting 1-3 decibels between 10khz-12khz. Also, any low frequencies 100hz and below should be rolled off and/or high-passed to add further low end control to your overall mix.
3) Vocal Compression Techniques: With compression, you are seeking to even out inconsistencies in volume levels while at the same time trying not to destroy the natural dynamics inherent in the vocal performance. The trick is to set your compressor with a high ratio of 5:1 to 8:1 with a semi-fast attack and a medium release time. Most important is your setting of the compressor's threshold: Set your threshold level where gain reduction occurs only for the loudest volume peaks in the vocal recording. This will even out level inconsistencies all the while retaining natural vocal dynamics.
1) Microphone Techniques: In order to achieve a professional high fidelity vocal recording, using a condenser mic along with a good pop-screen is the only way to go. Condensers capture vocal resonance and vocal frequency spectrums far better than dynamic microphones. Also, before recording, be certain to switch the mic's settings to the cardioid pickup pattern with the high pass filter enabled to remove low end rumble from the source recording signal.
2) Vocal EQ Techniques: If proper microphone techniques have been implemented, a minimal amount of EQ should be needed. However, if you find the vocals could still use added clarity, try boosting 1-3 decibels between 5khz - 7khz. If you're needing an extra airy texture added to the vocals, try boosting 1-3 decibels between 10khz-12khz. Also, any low frequencies 100hz and below should be rolled off and/or high-passed to add further low end control to your overall mix.
3) Vocal Compression Techniques: With compression, you are seeking to even out inconsistencies in volume levels while at the same time trying not to destroy the natural dynamics inherent in the vocal performance. The trick is to set your compressor with a high ratio of 5:1 to 8:1 with a semi-fast attack and a medium release time. Most important is your setting of the compressor's threshold: Set your threshold level where gain reduction occurs only for the loudest volume peaks in the vocal recording. This will even out level inconsistencies all the while retaining natural vocal dynamics.
