A QUESTION FOR THOSE CAR AUDIO EXPERTS

[mExIcaNox4]

WHAT WOULD BE THE BEST AMP I COULD GET FOR MY FOUR MTX T6.6 COMPONENT SPEAKERS

THE SPECS FOR THE SPEAKERS ARE

Size: 7
Sensitivity: 86 dB
Frequency Response: 55-20,000 Hz
Recommended RMS Power: 50W
Peak Power Handling: 100W
Impedance: 4 ohms

 

[Sneak]

well If you want to power all of them you have to get a 4 channel amp....they arent cheap either.

 

[gimpypimp]

Yeah...what Sneak said. Although you might be able to find a deal on-line somewhere.

What's your budget?

 

[UKantCMe]

i'm no expert, but can't you get a 2 channel amp and overload the 2 channels?

 

[ordekoms]

u need a 4 channel amp that is 100 watts per channel, (100x4)

Even 75 watts per channel would work(300 watt amp)

Since you said *best* i'd go with rockford or eclipse which is gonna run u anywher from $250-$350

 

[mExIcaNox4]

Multi-Channel Amp Specifications

Amplifier Type: Multi-Channel
RMS Power: 75W x 4 @ 14.4V
Bridged RMS Power: 250W x 2 @ 14.4V
THD at Rated RMS Power: n/a
Speaker Level Inputs: No
Preamp Outputs: Yes
Built-In Crossovers: HP/LP
Bass Boost: 0 - 18 dB
Frequency Response: 20-20,000 Hz
Channel Separation: n/a
Signal to Noise Ratio: >110 dB
Fuse Rating: 80 amps

how bout this one or is it to expensive ?

 

[MADIDIOT530]

YOU CAN USE A 4 CHANNEL AMP OR A TWO CHANNEL BUT YOU WILL RUN INTO OHM LOAD PROBLEMS, WHAT I WOULD RECOMMEND IS THIS HERE, YOU HAVE 4 SUBS, ALL ARE 4 OHMS, TOTAL YOUR LOAD IS 1 OHM, POWER AKOUSTIC MAKES A 1000 WATT AMP AT 1 OHM, SO YOU WOULD BE GETTIN 250 WATTS TO EACH ONE OF YOUR SUBS, THIS IS ONLY A 1 CHANNEL AMP BUT INSTEAD OF HOOKIN EACH INDIVIDUAL SUB TO THE AMP YOU RUN THEM PARALLEL AND LINK THEM TOGETHER HOOKIN ONLY ON SUB UP TO THEM AMP WHILE THE OTHERS ARE JUMPED OFF THAT SUB IN SERIES.

 

[gimpypimp]

^^^

He doesn't have subs.....

 

[Sneak]

If you want to go a cheap route get a deck thats like 50X4 output. Wire 2 of the speakers to the deck and get a 2 channel amp and wire the other 2 up to that.

 

[MADIDIOT530]

OH SHIT MY BAD, A MOTHER FUCKER IS HELLA RIPPED AND I THOUGHT I READ SUBS, HELL NO, DONT LISTEN TO ME, I'LL HAVE YOU BLOWIN THEM COMPONENTS APART.....MY BAD....YEA JUST A 4 CHANNEL AMP WOULD BE BEST, YOU CAN USE A 2 CHANNEL BUT YOU END UP SHARING WATTS IF ALL SPEAKERS ARE HOOKED TO IT.....BUT LIKE SNEAK SAID YOU CAN RUN 2 OFF A TWO CHANNEL AMP AND THE OTHER 2 OFF DECK POWER, BUT IT WOULD BE BEST TO GET A 4 CHENNAL AMP SO THEY ALL GET THEY SAME WATTS...YOU WILL HAVE LESS DISTORTION THAT WAY